BassPro II
BASSPROII AUTO SUBWOOFER SPECIFICATIONS
GENERAL CONDITIONS: TEST INPUT SIGNAL FOR LINE IN - 2CH/60Hz/250mV.
TEST OUTPUT - 1 W ATT 4 Ohms LOAD (Bridge).
POWER SOURCE DC14.4V/12A min
TEST CONDITIONS: ALL TEST SIGNALS FROM LINE IN UNLESS OTHER REMARKS.
CROSSOVER VR AT MAX POSITION UNLESS OTHER REMARKS.
UNIT NOMINAL LIMIT
1. TOTAL OUTPUT POWER W 100
2. OUTPUT POWER (1 CHANNEL) W 22 20
(60, 400; 5.0% THD)
% 0.3 0.5 MAX
3. THD AT 1.0W (60,250;)
4. SIGNAL TO NOISE RATIO dB 70 65 MIN
(60,250; O/P=1W;)
5. FREQUENCY RESPONSE (60-120HZ) dB 60Hz 0REF
(-- , 250; O/P=1W) 120Hz -1.6+/-3
180Hz -6.5+/-3
6. CROSSOVER RANGE MAX TO MIN dB -12+/-3
(120,250,O/P=1W,MAX REF)
7. CROSSOVER SLOPE dB 12
8. INPUT SENSITIVITY
(60, --;O/P=18W,L+R, GAIN MAX) LOW - INPUT mV 340 +/- 60
(60, --;O/P=18W, 2CH,GAIN MAX)
HI - INPUT V 3.5 +/- 0.6
mV 0.8 1.5 MAX
9. MAX GAIN NOISE, GAIN MAX )
mV 0.5 0.9 MAX
10. MIN GAIN NOISE, GAIN MIN )
11. AUTO SENSE AUTO ON LEVEL V 1.8 +/- 0.5
(--, --, HI-N, 1CH) AUTO OFF TIME MIN 3.0 +/- 1.5
12. PROTECTION CIRCUIT
SHORT SPK TERMINAL +/- Functional
(60,250,O/P=10W)
13. FUSE RATING A 20
14. MAXIMUM CURRENT DRAW A 12
15. IDLE CURRENT DRAW mA <800
16 1/8 X 9 1 X 12 1?
16. DIMENSIONS
(410 X 242 X 312MM)
2 |
ACEC
